My receiver is a year old. Here is what I just did. Did a factory defalt, loaded factory file, tuned off A-1 Module, rescanned sats, turned module back on. getting chnls 101 & 500. I then loaded may 31 bin and then the latest IHUb bin. I then did steps 2 thru 10. My IHUB is pluged in to my router, the lits are on at the hub but still not connecting to server. I reset my modem and then my router but still no luck. I think this IHUB is defective and needs to go back. One thing that did happen is that I lost the Two HD channels(9491 & 9421) that I was getting before I did the factory Default.
Quote:
Originally Posted by San
fitterit is your receiver brand new, if not you load the file like below:
1. Load bin ( over current file if not virgin reciever) if receiver is new, load factory file then the May 31 ihub fix and then the latest fix for the Ihub, reason for this is because the very first ihub fix was beta and the second one is not, and all the rest that followed were updates, so you need the second one in your receiver then the last one if your receiver is new only, make sure Ihub is not connected at this time.
2. Plug in dongle/Ihub
3. U will see prompt that dongle/Ihub connecting (can take up to 30 secs)
4. Click menu-installation-ipconfig
5. Setting type DHCP
6. USE DNS YES
7. Domain name svftaiks.com
8. Server port 1920
9. PUT IN YOUR SERIAL NUMBER BE CAREFUL THE LETTERS ARE VERY SMALL
Entering serial number for iHub
The serial number for the iHub as well as many electronic devices is in hexidecimal. Hexidecimal (commonly referred to simply as "Hex") only has 16 characters. They are the digits 0 through 9 and the letters A through F. If you look at the serial number for your iHub you will notice the letters are small lower case letters and may be hard to read. For instance the letter "e" may look like a letter "o" with a slash through the middle but trust me it is an "e". When you go to the setup screen for entering the serial number look at the bottom of your screen and you will see a key for which remote buttons to use for the letters. Now just simply enter them and save and you are done
Use the PVR control buttons
there is a guide at bottom of serial # page that tells you
rewind button=A
play button=B
fast forward button=C
stop button=D
arrow right button=E
pause button=F
10. Go to apply and click OK (don’t exit or it wont save you must click apply)
|