Problems with the remote control
Check that nothing is between the remote control and the remote sensor.
Make sure the remote control is in STB mode. Press the mode switch to the STB position so the remote will control the FTA Receiver.
Check the batteries in the remote control. They may be weak, dead or installed incorrectly. Try replacing batteries.
If you’re entering a channel number that is less than four digits long, the receiver might wait two seconds before tuning to the channel. Press ENTER after entering a channel number to tune immediately.
If you are trying to operate a device other than the FTA Receiver that you have programmed the remote to control, make sure you fi rst slide the input switch to the corresponding device (DVD player, VCR, etc.). The indicator light for the component you’re trying to control should light up when you press a valid key for that component. If it doesn’t, make sure the input switch is clicked into the correct position.
(Note that when you replace the batteries, you may have to reprogram your remote to control other devices.)
|