Working With The CW 100R

To install firmware to the CW600P rename the newest downloaded bin file to SETUPBOX.bin.

To install the latest firmware for the CW 100R rename the newest downloaded bin TVBOXROM.bin. Save the files to your thumbdrive or hard drive and connect the device you are using to transfer the files to the CW100R.
Turn on the CW100R and press the menu button on the remote. Select “Play file” and find/select the file you renamed (TVBOXROM.bin) and press okay. This should install the file and update your CW100R.

To install firmware to the CW600P you need to connect the CW100R to the CW600P using a Null Modem cable. Then turn on the CW100R. Make sure you have the device you are transferring the file from connected to the CW100R. Put the CW600P in standby mode by turning on the receiver using the power switch on the back of the unit and then pressing the power button on the front when the display reads “0000”. You should then see the display show “----“. When you see this then the receiver is ready to accept the update. Press the menu button on the CW100R remote. Select “Play file” and then select the file you have renamed (SETUPBOX.bin).

Press the OK button on the CW100R remote to start the update. Remember do not shut the power off to the units while they are updating.
Once complete remove the Null Modem cable and connect the (straight) serial cable and that will allow you to choose programming using the EPG of the CW600P to record onto your hard drive or thumbdrive. The CW100R requires drives which have a fast write speed. If you have choppy video on playback then the speed of your thumbdrive or hard drive may not be adequate.