This is the files you need to convert your Captive Works from summer SW to Kround SW

You will have to first use loader 1.04 to load Kround SWv1.06 under boot mode.

Once done reboot reciever and put it in stand by mode, to do this power up from the rear switch after unit is on then hit the power button on the front of the box ..|..

Then open loader 1.05 and load the loader 2.50 SW

Once done load the latest CW600S bin, scan sats and enable the patch by hitting f-1 you should see an H on the front of the reciever then hit 000 and exit out.

There is a read document enclosed in this file i got this some where else.

All you need is this file and the latest release for Captive Works 600s by Kround

NOTE:if you have the kround software in your receiver from now on you MUST use the V1.05 tool to update your software and you CANNOT go back to the old summer version.

DO NOT DO NOT put this file into any other receiver other than Captiveworks CW-600S receiver because that could damage your receiver.

Please make sure when you upload the files, that the power is always on..
if you shut down the power while its loading, it will damage the receiver.

EDIT: added the long channel names files necessary to activate this feaure load these files last, after updating with the newest CW600S bin using the instructions note.txt file

Attached Files

NEW_CW600_OS1.06.zip (1.33 MB, 15 views)