Load the new file and set auto roll to "ON" and wait up to 15 min for the keys to auto roll.

Make sure that the Auto Roll feature is turned "ON." You will find the Auto Roll feature in the Menu options.

If you don't have the picture after 15min Reboot your system using the switch at the back of the receiver.
Switch the receiver OFF then back ON using the button on the back of the receiver, the signal will return.

* Change*
( Main software upgrade )
- AR Fixed

Note:
- Always use Remove Device Safely function in USB Menu before remove USB drive (thumb drive/USB HDD)
- Always format USB thumb drive before any update
- Do not extract file direct on to the UBS thumb drive, extract to a folder then copy to USB thumb drive.
- Do a hard reboot (power OFF-ON using rear switch) after every update.

Follow instruction carefully when inputting serial number. Do not use Published Serial Numbers as each box has its own and if serial number you input now does not match serial number on SECURITY CHIP your box may not work on future releases. All boxes will work on this release no matter what serial you use but you will not have another chance to change it to correct one later. Do not use serial from another box as in later files it will check to see that you match the correct serial for your unit from SECURITY CHIP on board. Remember just because you can input any serial this time do not think it will work on next release. It will check what you put this time on next release not this release. So follow instructions.

Attached Files

CaptiveWorks 800 Fix Oct.29.2008.zip (1.06 MB, 8 views)

__________________