The only option I changed here was the TimeOut. I changed it from 3 sec to 8 sec. This gives you more time between keystrokes when you're entering channel numbers.
Press Exit, Exit.
Select Accessories
Select Setup Wizard
English, Ok
English, Ok
Select your time zone. For EST, select GMT – 5:00. If you're not sure how to set this, look in the front of your phone book. providerproviderproviderprovid er Canada has a map of North America that shows the different time zones and the GMT offset. I set mine for GMT – 5:00 (EST) Press the right arrow to turn on SummerTime. (also known as Daylight Savings Time)
Press Ok
Press Ok again.
The antenna setting screen will appear. Scroll right/left to the highest numbered satellite you have.
Scroll down and enter the settings for your setup.
I'm using Echostar 119 & 110, so here's the settings I use:
Satellite Name: 17.Echostar 7 (119W)
Transponder : 12239/H/20000/5/6
LNB Freq. : 11250
LNB Type : Normal For D!ish pro set to OCS-DP
22 kHz : OFF unless you use one, then set it to ON
Diseqc Number : LNB 1 Note: LNB 1 = Port 1 on switch
Legacy SW : OFF
Motorised System : OFF


When you are done, press the Red button on the remote marked Audio. This will start the scan for this satellite.
The prompt “Only FTA channels search?” will appear. Select NO, press Ok.
When the scan is done, the antenna settings screen will re-appear. Scroll to next satellite you have, scroll down and enter the correct settings for this satellite.
Here's the settings I use:
Satellite Name: 23.Echostar 6,8 (110W)
Transponder : 12224/V/20000/5/6
LNB Freq. : 11250
LNB Type : Normal For D!ish pro set to OCS-DP
22 kHz : OFF unless you use one, then set it to ON
Diseqc Number : LNB 2 Note: LNB 2 = Port 2 on switch
Legacy SW : OFF
Motorised System : OFF
When you are done, press the Red button on the remote marked Audio. This will start the scan for this satellite.
The prompt “Only FTA channels search?” will appear. Select no, press Ok.
When the scan is done, the antenna settings screen will re-appear. Scroll to next satellite you have, scroll down and enter the correct settings for this satellite.
When you're done scanning all your satellites, press Exit, Exit, Exit.
“Sorting SID” will appear, ( if you chose that option).
When the screen comes back up, press F1 000.
“Patch Enable”should appear.
Power off, then on at the back of the box.
Watch TV.


Once everything is up and running good, I save the channel list and settings to the USB stick that I use for loading bins. This saves re-configuring and re-scanning all the sats each time there's a new bin.
To do this:
Power off at the back of the box.
Insert the USB stick and turn the power back on.
Press Menu
Select System Settings, ok
Select User Channel List, ok.
Select Save, ok.
Select Yes, ok.
Enter your name,( ie. Bob) then press the Red button on the remote marked Audio.
Press Exit until you get back to watching TV.