Instructions how to use the loader software for captivework ultima

There is 2 ways of loading the file. One is using the Null cable and the other is using USB Stick. You can use either or.



How To Load Bins On CW Using NULL Cable.

--------------------------------------------------------------------------

1. Power STB OFF using the back switch.
2. Connect NULL cable to computer and STB.
3. Open CW loader.
3. Turn power back ON (Let the STB boot up completely).
4. Press power button on the front panel to put the STB on "Standby Mode" -- -- -- --
5. Browse and select the latest bin file and press "Start"
NOTE: Do not interrupt the loading process, wait until the front display shows "END".
6. Turn power OFF and ON again, let the STB boot up until it shows 0000 on the display.
7. Factory default the CW (menu > installation > factory default), set the antenna settings, autoscan (red button) . Enable the patch (F1 then press 000).Wait for box to autoroll.
8. Sort channels by "SID" (menu > System Setting > scroll down to channel and change it from "Normal" to "SID" and exit.
9. Turning autoroll ON/OFF if needed for manually keys entry (Menu > System setting > System > OSD > Scroll down to autoroll.

--------------------------------------------------------------------------

Guide to Loading Your CW Using USB

1. Plug in USB w/unzipped files into CW (USB READY WILL APPEAR)
2. Press the USB button on the remote
3. Scroll over and select the SOFTWARE TAB
4. Find new file and press OK
5. When finish press YES to reboot
6. After reboot factory default (MENU>INSTALLATION>FACTORY DEFAULT)
7. Set antenna settings and scan satellites
8. Enable the Patch (F1 then 000)
9. Wait for box to autoroll

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.