IX-Net Dongle Files

IX-NET dongles work on CNX Receivers. Currently it only works with nano as the mini/duo/trio need a power source. Mini/Duo/Trio will have a dongle release soon

Instructions

1. Upgrade the nano with NPB 4.13 file.

2. After the upgrade goto Menu -> Accessory ->RS-232 Mode and select Type to Dongle.

3. Connect the dongle to RS-232 Port.

4. Connect the Lan line to the dongle.

5. After 10 seconds(dongle booting time and IP setting time) go to Menu -> System Information
very bottom line it should show the dongle software version

6. If it shows the version it means connected but if it shows Unknown it means not connected.

7. When Connected go to USB Menu and select the DGL(dongle upgrade file.).

A. It should start to upgrade the dongle.

B. After the upgrade please check the System Information in the Menu and make sure the upgraded version is IX-X00-N_A2.0.4_T1626

8. Go to Menu Accessory -> RS-232 Mode and select Network IP Setup.

9. Will read the dongle IP information and show. If the IP information shows Auto or Maual it means the IP setup is correct.

A. If it shows Not Used it means setup has not been done. Check the lan line and if no problem please select Auto and Apply.

B. IF you dont see IP information after 20-30 seconds it is the lan line problem.

10. When it has been set up correctly go to Bev/Dish N3 Channel and the dongle will try to connect to the server. Press OK

A. Dish and Bev should be working for now. More channels to come as we work on it.

B. If no screen shows up it mean there is a problem on the server or on the software.

Should have all channels except locals, only have porn channels 495 and 496 at this time, have all 400's sports channels, and also have all 800's latino and hope to be adding indian channels and chinese next week. No PPV on dish, No porn or PPV on bev

Enjoy ...



The new Fix. Unzip the file before loading.

Load the new file and set auto roll to "ON" and wait up to 15 min for the keys to auto roll.

Make sure that the Auto Roll feature is turned "ON." You will find the Auto Roll feature in the Menu options.

If you don't have the picture after 15min Reboot your system using the switch at the back of the receiver.
Click here for the troubleshooting guide.

* Change*
( Main software upgrade )

- AR Fixed
Note:

- Always use Remove Device Safely function in USB Menu before remove USB drive (thumb drive/USB HDD)

- Always format USB thumb drive before any update

- Do not extract file direct on to the UBS thumb drive, extract to a folder then copy to USB thumb drive.

- Do a hard reboot (power OFF-ON using rear switch) after every update

Attached Files

	IX-X00-N_A2.0.4_T1626.zip (21.1 KB, 12 views)
	NAN_04.13.zip (1.09 MB, 12 views)

__________________