I have lnb with 2 c and 2 l on it can i run 1 c to the motor and run 1 l by-pass the motor go to a 4x1 diseqc switch on the switch give number 1 to the c and number 2 to the l on the switch will the c and the l both work if the l will work i could go to fta sat with out going to the dish to change it ? I tryed the c and the l to the motor with a t and it did not work thanks studmuffen

hi ya studmuffin. c= circular l=linear these are for reception fields. you should run a connection staight to your lnb from your receiver. yes you can run your lnb with a switch.each lnb should have it's own switch. something like 110 satellite to number one , 119 to number 2 . d*sh is a circular signal. remember the old satellite you picked up in latin lanuage, it was a linear signal. nice ton hear from you again. good luck.

hey i found this. has alot of info and also lnb instuctions. good reading. http://www.ftaprofessionals.tv/usefu...ime-setup.html

nice hear from u tell san hi i going for fta i have it on my dish but my lnb is on c not l i like to get it on c and l on a switch but i have a motor so i have the lnb c on it i was going to run from l to a switch to receiver and the c with the motor to the switch to the receiver will that work thank studmuffen

Take a look at this link, it shows you what sat's are C Band and what kind of dish you need to get them >>> http://www.ftaprofessionals.tv/dishe...satellite.html

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.