NOTE: Before loading any Bins please go to Menu, find Receiver Information and on a Piece of paper write down what is displayed on the screen so that if for any reason, the Box should lock up, you can then start your own Thread and post this info so that we have something to start with.


1) Download and install Limesat HD MAX Japan v212 0812 bin .... Plug in flash drive and from popup select Limesat HD MAX Japan v212 0812 bin.

2) Go to installation menu & Dish Settings.

3) Go to Installation > Dish Settings & put in your settings & scan.(red button) once you have proper sat lock

4) If you notice that you are missing any channels, you can go to manual scan

5) Select TP freq for missing Channels and press Red Button to scan once you have Proper sat Lock

6) Should HD Channels be missing, Go to Manual Scan>Hi-lite your sat select turbo 8psk for the correct Tps & save changes. Do this for each of your sats. (for sats with HD)

(5) Do all your settings, time etc.


Using the Limesat Japan Public Server

1) Go to server settings,Menu>Configuration>Ne twork Settings

2) Connection Mode DHCP

3) Click Blue button for Server setup

4) Server is Limesat Japan Public Server > to turn Server ON

5) Click OK on the Limesat Japan Server Line

6) Scroll down to ID, Press Ok to Edit, delete 'dummy'

7) Enter your Warranty Code ( if you have none yet, contact the ppl you bough the LS HD Max from for the code) meanwhile you may get a Trial code from LimeSatJapan | Just another WordPress site

8) Enter the Code, Exit and press the Red Button to save

9) Press Red Button to Scan Server

10) Will Ready when you are good to go

11) Exit, exit, exit and click on CH 200 or 2400 or 2500 for BEV

Using any P$S of your choice

1) Go to server settings,Menu>Configuration>Ne twork settings

2) Connection Mode DHCP

3) Click Blue button for Server setup

4) Select each one & put in your settings. Note: Leave 1 and 2 open , use 3 and up.

(7) After each setting just exit. When all are done, save. Note: If you have to select any symbols, like the #, it won't show until you exit.

(8) Go back to server settings window & scroll right to turn on server.

(9) Select re-activate server.(red button)

(10) Repeat for each server if needed.

(11) If you have more than 1 server, you can enter them all. It is not necessary to disable any of them.When you select a channel the box will cycle through all your servers to find which one has the channel open.

(12) It may say "network connect, 0 servers". This a bug, when you exit & go to a channel, it will be there.


Note:


1) For Bev channels use '2' as a prefix for the regular channels ie: For TSN on BEV key in 2 4 0 0

__________________