|
 |
 |
 |
 |
 |
 |
 |
ChatBox Sonicview Conaxsat Nanosat Viewsat i-Link DreamboxLimesat Topsat AzBox Satzen X-Factor |
 |
 |
01-26-2012, 04:10 PM
|
||||
|
||||
Limesat in Boot loop FIX
1.Start loader and set com port.
2.Select file to load. 3.Reboot box and hold power button on box in for at least 5 seconds while rebooting boot should freeze in display. 4.Press start on loader and file should begin transfer. When countdown is less than 4 digits numbers are prefixed by letter A. 5.When display hits zero should change to -E5- WAIT !!!! display on loader should be at 90% at this point.Receiver should then start counting down prefixed with a "P". I assume that is for 'PROGRAMMING' 6.When receiver displays -End- wait a few seconds, look at loader program should now be complete, and then reboot box. Also you can try removing all cables let it set from 15 to 30 mins, and rehook and see if that corrects issue...
__________________
 |
 |
| Bookmarks |
| Thread Tools | |
| Rate This Thread | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| won't boot | haber | i-Link Discussion | 3 | 01-02-2012 07:27 PM |
| Out of the loop for awhile | stuartlittle | Dishes & LNBs | 1 | 10-10-2009 04:54 PM |
| Using the loop out on cw700s | Holly81604! | CaptiveWorks Discussion | 7 | 06-16-2009 07:11 AM |
| boot | steve24 | Sonicview Discussion | 1 | 04-05-2009 06:47 PM |
| How to fix BOOT-LOOP problem | Fta Professionals | Viewsat 9000 HD Instructions | 0 | 09-22-2008 02:23 PM |
 |
 |
