If you were using the nfps setup you will need to convert back to S.U.N.S.If not load the 1.54.2 (255) file in receiver.You want to see the suns message as follows I-on/N-on/P-off/Emul-off/suns disconnected later it should show suns connected if noi is correct.

Set up receiver set local time and user settings and scan sats.

Go into network settings and check for ip's and that your on dhcp.Then exit and put receiver on cnl 200 cnn.

Install noi 131a program on pc.

If you only use either 1 dn or bev server then enter server info in the settings tab and click save.

Then go to main tab and click start.The tv screen in noi should go fuzzy and you should see server 1 displayed and a cnl number.When noi connects to your ps you should see a countdown clock and also see server 1 and cnl number turn green and receiver should start working.The countdown clock will always show counting down.

If you want to run dn and bev with multible servers go into advaned tab and highlite south server 1 then click edit.Enter all the server info then click save.Now highlite north server 1 and click edit and enter all server info and click save.Then put a checkmark in use these settings.Then go to main tab and click start.Then noi will take you to the moniter tab and you should see server 1 and cnl in south or north depending on whether your on a dn or bev cnl.

For adding other servers edit in server info in the next server lines which would be server 2 or 3 etc....south for dn and north for bev then click save.

At this point you should be watching tv.

Note:you can not edit sever info in noi while it is running.You must click quit on main tab and then re-open noi and edit server info and click save.Then go to main tab and click start.

__________________