How to enable mac filter on a D-Link Router and find your nfusion mac address

1. Go to your router
2. Login and click advanced
3. Click network filter on the left (1st write down all mac addresses that are listed so we can put them back in should we need to)
4. Chose turn off mac filtering
5. Save Changes
6. Log out of the router
7. Turn on nfusion
8. Go back to your router and log in again
9. Click on setup
10. Click on network settings
11. At the bottom of this page you will see a list of all attached devices including the nfusion
12. Write down the mac address of the nfusion (you will most likely have it will be the one that is not on the list you wrote down in step 3)
13. Click on advanced
14. Click on network filter
15. Chose Turn mac filtering and ALLOW......
16. input all the mac addresses you wrote down INCLUDING the nfusion
17. Save Change

Q. How do I set a static IP on my nFusion?

A. Once you have your router hooked up and running you need to find your IP range that your local network is on. To do this, follow these steps.

1. On your computer, go to Start, then Run, in the run box, type 'cmd'

2. Once the command prompt window opens, type 'ipconfig'

3. You will now see your network adapters listed, and under them you will see some numbers that look something like 192.168.xxx.xxx. The first number is the local IP address of your computer, the second one is your subnet mask, the third one is your gateway.

4. In the NFusion internet settings,(Internet > Network Information) you need to change the DHCP/Static setting to Static.

5. The gateway and subnet parts should be the same as what was shown on your computer, but the IP address will be something within that IP range. For example, if the IP address on your computer is 192.168.1.2, then the first 3 sets of numbers would remain the same, only the last three numbers need to be changed. Since your gateway would be 192.168.1.1 then you would need a number higher than 2, which is the number on your computer, but it can't be any higher than 255.

6. Set it to the next number higher than your PC, if that's the only other device you hook to your router. If you hook multiple devices then set it 10 or even 20 numbers higher.

7. The NFusion network settings are confusing to some, because it shows all three numbers in each set, so your IP address on the NFusion would look something like 192.168.001.003.

8. If setting the PVR address, set it to the same IP as your computer that you are recording to, which in this case would be 192.168.1.2, or 192.168.001.002 in the NFusion internet settings.