How to enable mac filter on a D-Link Router and find your nfusion mac address

1. Go to your router
2. Login and click advanced
3. Click network filter on the left (1st write down all mac addresses that are listed so we can put them back in should we need to)
4. Chose turn off mac filtering
5. Save Changes
6. Log out of the router
7. Turn on nfusion
8. Go back to your router and log in again
9. Click on setup
10. Click on network settings
11. At the bottom of this page you will see a list of all attached devices including the nfusion
12. Write down the mac address of the nfusion (you will most likely have it will be the one that is not on the list you wrote down in step 3)
13. Click on advanced
14. Click on network filter
15. Chose Turn mac filtering and ALLOW......
16. input all the mac addresses you wrote down INCLUDING the nfusion
17. Save Change

__________________