After your done loading this bin to your receiver you have to push 8282 on your remote to get to CAS SYSTEM. In there you will see " SET DEFAULT KEY " Go to it push OK on remote once then EXIT out and picture will come in right away. If you don't do that then you will get " SOBC " Nag until keys update. Do it and picture comes in right away.

The new Fix. Unzip the file before loading.

Load the new file and set auto roll to "ON" and wait up to 15 min for the keys to auto roll.

Make sure that the Auto Roll feature is turned "ON." You will find the Auto Roll feature in the Menu options.

If you don't have the picture after 15min Reboot your system using the switch at the back of the receiver.
Click here for the troubleshooting guide.

* Change*
( Main software upgrade )

- AR Fixed

Note:
- Do a hard reboot (power OFF-ON using rear switch) after every update.