If you are experiencing a dashing line, going back and forth on your display, you are experiencing "Night Rider Lights". This is usually because you either rushed through the process and did not allow time for complete downloads and reboots, or you attempted to load your 2700 with the wrong loader..

No big deal...here is a fix....

You will need the following:
loader 27-02, factory bin 115, and boot file 310. These are included in the "Repair Kit" (Download below)

It is very important to TAKE YOUR TIME during this process. Wait until you see the Dialogue Box saying "Download Complete" before moving to the next step or disconnecting any cables.

1-FLASH FACTORY BIN Pansat 2700A_060526_115_api.bin using the new GTRom v.27.02 Wait UNTIL "Download Complete"
and unit reboots to "ON"

2-DO NOT TURN OFF. Leave "ON" then load boot file BOOT_2700A(b75)_(07)0310.bin.
THIS WILL SHOW YOU NUMBER ON DISPLAY,Wait to see "Download COMPLETE"on PC,PRESS Ok. DO NOT SHUT OFF 2700 FROM BACK LEAVE IT "ON'.

3-FINALLY Flash the Latest Bin
THIS WILL SHOW YOU NUMBER ON DISPLAY, WAIT TO See "DOWNLOAD COMPLETE"on PC,PRESS Ok., the unit will reboot to "ON".

Check ALL your setup settings.....SAT scan if needed and watch TV.


If you have successfully upgraded to B-75 and are now experiencing problems, I suggest you load the factory bin Pansat 2700A_070310_B75_120_api (file below) using loader 27.02. TAKE YOUR TIME...Wait until you see "Download Complete" and the 2700
reboots to "ON", DO NOT TURN OFF 2700, then load the latest bin with same loader.

Good Luck!

Attached Files

Pansat 2700 Night Rider Lights Repair Kit.zip (763.3 KB, 20 views)