|
 |
 |
 |
 |
 |
 |
 |
ChatBox Sonicview Conaxsat Nanosat Viewsat i-Link DreamboxLimesat Topsat AzBox Satzen X-Factor |
 |
 |
|
|||||||
| Pansat Discussion Post your questions, comments or concerns below Files and Instructions. |
 |
|
|
LinkBack | Thread Tools | Rate Thread |
01-23-2009, 09:45 PM
|
||||
|
||||
Did you convert to PUFF-boot_Ver1.0.3 and followed all instructions carefully. Make sure you don't miss any steps and use right loaders and then load the latest file that was posted for your receiver Fwank7_Jvvh-Team-PUFF_(Lzma)_V207 bin. Only _(Lzma)_ files will work from now on and it's reported working fine.
__________________
 Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too. 
|
|
01-24-2009, 04:20 PM
|
|||
|
|||
|
Fwank bin 206 and 207
My Pansat plays for a while than go out to scramble bad chennal than a few min later comes back in. Is there a diff between Fwank bin 206 and 207 if so which one do I used.
Thanks
|
|
01-24-2009, 07:46 PM
|
||||
|
||||
|
Use the one that was posted last 207. Here is the link http://www.ftaprofessionals.tv/showthread.php?t=2223
__________________
Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.
|
|
01-25-2009, 01:17 PM
|
|||
|
|||
|
Still Down
I am using Fwank bin 207 and it still not working. This time it don't play at all, it show the chennal that the tv is on then about 10-15 min later it gose to scramble bad chennal. Bin 206 will play for a while then show scramble bad chennal than a few min later comes back on. I did convert to PUFF-boot_Ver1.0.3 before adding bin 207 and I followed all instructions carefully. Help!!!!!!!!! what can I do.
Thanks in advance
|
|
01-25-2009, 06:20 PM
|
||||
|
||||
|
Do a factory reset, do a blind scan for your sat's and make sure to turn your autoroll off. This should fix your problem. Leave feedback and let us know please.
__________________
Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.
|
|
01-25-2009, 09:46 PM
|
||||
|
||||
|
Happy to hear you got it working. No you shouldn't have to do factory reset next time you load the new file. If the channel list isn't working just load it over the fix using channel master.
__________________
Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.
|
|
| Bookmarks |
| Thread Tools | |
| Rate This Thread | |
|
|
 |
 |
