I put up the newest di$h Di$h today 110 119 129 in my sat menu what should i select and and what settings the switch i was told is built in the head so i have no switch inline I am getting some stations allready on echo7 but Alot are missing do i need to do a blind scan? I guess i don't see the 119 and the 129 sat

I assume you got 1000.2 dish, if that is the case these are the settings for that dish.

PM. Please don't post in files section, this thread will be moved to Pansat discussion section.

1000.2 Dish


Satellite:-------------119°---------110----------129
LNB Power:------------On -----------On------------On
LNB Type:-----------OCS-DP-------OCS-DP-------OCS-DP
LNB Frequency:-----11250--------11250--------11250
Transponder:--------12239--------12224-------12282
22khz:----------------Off------------Off------------Off
Search options:-------All------------All------------All
Network search:-------On------------On------------On
Diseqc :---------------Port 1--------Port 2---------Port3
Motor:----------------Disable-------Disable------Disable
Legacy Switch:--------Off------------Off------------Off

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.

do i select dishpro? what are the names of the satellite when it says locked almost always says 110 locked echo 7 is the only one working

Yes that is a dishpro, all three satellites are Echostar sats.

DISH 110
Sat Name: Echostar 6.8 or 8.6 on Pansat should be 8.6 if i remember correctly.

DISH 119
Sat Name: Echostar 7

DISH 129
Sat Name: Echostar 5

You can read some more about that dish at the links posted below.

http://www.ftaprofessionals.tv/dishe...-meanings.html

http://www.ftaprofessionals.tv/dishe...w-install.html

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.

are you 100% sure my results are not good what can I tell you to re-evaluate

You said you have the newest DN dish and i assume it's 1000.2 Dish. If you have that dish then these settings should work for you. How is your Signal and Quality, what is the S&Q % ?

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.

signal 92% quality 90% when i set up the peramiters it will start to scan then wont go past 0% done

Scan one sat at the time then exit and repeat the same steps for other sat's.If regular scan isn't working try blind scan and see if that works.

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.

it seems that only the one under the # 2 switch position works 1 and 3 do not

Your port # are probably wrong, pick one sat and change port # to see which one has the best signal and quality and then scan it. Just remember don't scan the same sat twice, once you figure it out write it down for future references. It all depends how your LNB's are set up and what port is used for what sat.

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.