Satzen Z500 Setup Guide


1- Always Load the Latest files Please Refer to the Download Section
First you have to download Factory file 1.01. and loader file 2.04 and unzip them into a USB pen drive


2- Go to menu on your Sz500 and select USB from utility tab and Load first the factory file 1.01 your Sz500 using the USB port .The box will reboot by itself after loading a file

3- Then load loader file 2.04

4- Once both files have been loaded, go to menu, installations(tab) and set antenna and lnb's and diseq.

5- Then select the sat you will use and scan channels.

6- Then need to setup your network connection

7- Go to menu, options, network setting, and select IP setup. Normally you set it to AUTO and select apply, the IP addresses should show. . Make sure you are connected to Internet and that you are getting the network addresses on your Sz500.

8- You can check connection by selecting a channel and in the lower right of your screen it will show "connected " , Not connected" or "not registered".

9- If it shows not connected you have to work with your modem or router.

10- If it shows not registered you have to go to menu, options, network , net application and on type select Zstream.

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.