iHub, how to get it re-talking to the I-net ......by-putski- 2009.06.10

This assumes that you have a operating DSL internet, and the hub is connected to the receiver and internet. The receiver has the current iHub software (.rom) installed. The iHub has been working, but it is no longer. This is what you need to do.
First with all power off, connect the hub to the receiver and internet connection.
Power up in sequence, the internet (modem and router), then the receiver.
After the receiver boots, then with remote goto Menu - Installation - IP Config
The header should say "User options"
Setup should match this post; http://www.ftaprofessionals.tv/sonicview-360-elite-instructions/4255-sonicview-ihub-configuration-set-up-instructions.html
Setting type DHCP - USE DNS YES - Domain name svftaiks.com - Server port 1920 - PUT IN YOUR iHUB's SERIAL NUMBER BE CAREFUL THE LETTERS ARE VERY SMALL
Now just simply enter them and Go to "Apply", click "OK".
Once above is done; Go to

"Setting Type" field and change to "Static" (this will allow you to access these fields);
Change the "Local IP" field to all zeros (000.00.0.0)
Change the "Local port" field to all zeros (0000)
Change the "Subnet" field to all zeros (000.000.000.0)
Change the "Gateway" field to all zeros (000.000.0.0)
Go to "Apply", click "OK

Now go to "Setting Type" field and change to "Static"
Go to "Apply", click "OK
Exit out.
The receiver should now be receiving and decoding the channels that are currently listed in the iHub list.
If not receiving, then; Power up in sequence, the internet (modem and router), then the receiver.
After the receiver boots, then with remote goto Menu - Installation - IP Config
The header should say "User options"
The fields previously with zeros should now have digits in them, if so, the hub/receiver is talking to the internet, if not check your internet equipment, and recheck the iHub setup.

__________________