Important Read For All Ihub Users

It may be needed to reset your providers router to pickup the IP change for the ihub .

heres the way to make that happen

if your down try this

make sure DNS is on YES

remove Ihub from sv
and from cat5 cable
power off sv
wait 5 secs
power on sv
make sure you have pic on 100
put dongle in
wait for Ihub INI screen
than go to 200

this should allow the ip change to be updated

__________________

I have a sonicview 360 elite with a i-hub connected and I have both lights lite on back of receiver I believe I have it connected correctly because I will receive channels 175,152,151,149,121,323,321,41 4,313,307,and309 and they will freeze ocassionally but come back in. My question is what do I have to do to get all the channels that are on the list that are operational ? I have the sv209 and the 1,4 file loaded in my receiver and I think my setting are correct thank you Angel

If you are receiving some of the channels than most likely is your dish settings.
Here is the link where you can see all the working channels: http://www.ftaprofessionals.tv/sonic...html#post16017

Let us know your dish settings.

__________________

• Want to know when the new FTA Fix files are posted?
• General Helpful Hints on Forum Posting

My dish setting for echo star 7 are tuner 1, connection separate,lnb,ocs-dp,lnb freq.11250, trans. 12224, Diseqc is port2 foe echo star 8.x tuner1, conn. separate, lnb ocs-dp lnb freq 11250, trans. 12239, Diseqc is port 2 hope this is what you need for the help I need Angel 45

You are showing that sats ES8 110 and ES7 119 are on the same port that is wrong.Change 119 to port 1 and to show lock on 119 set tp to 12239.

__________________

Heres your problem as zero gravity said

you go into ur menu settings and then do into diseqc and change it,,sat 119 is echo 7 and put it on port one then go and change the other sat 110 echo 8 10 to port 2,,,,and if it dont work that way then go back and change them settings around sat 119 to port 2 then sat 110 to port 1 depending on how you are wired to lnb....let us know if you got it working corectly thanks

__________________

LMAO Zero said what?

__________________

I tried e7 and did a sat scan and pulled 422 tv channels on port1 but after scan it said failed and I do not get all the channels in. on sat e-8 on port 2 I scane 622 tv channels and they all don't come in very few as a matter of fact after sat scan it to said failed,I don't know what to make of this or what to do to correct it, need some help as I am very new to this stuff thank you Angel 45

Along with the other problems I am having I seem to be expiercing a lot of freezing of my picture any suggestions angel 45

Like I had already said you will not get all the channels you scanned in.Below is a link to a list of what may be working.How is your receiver connected to the internet?I booted my sv up and channels working good from what I have checked.




http://www.ftaprofessionals.tv/sonic...07-2009-a.html

__________________