For those that are having success with the IHub can you tell me what the lights on the hub are doing when it is working, are they on steady or do they flicker? Also what would be a working channel to try on sat 119 or 110?

The green light should stay on and the orange will flicker.

Channel 200 ( CNN ) is a good channel to use for testing.

Sonicview changed the IP so you will need to rest the iHub to make it work and new files are out.

Load the new file and than do this :

It may be needed to reset your providers router to pickup the IP change for the ihub .

heres the way to make that happen

if your down try this

make sure DNS is on YES

remove Ihub from sv
and from cat5 cable
power off sv
wait 5 secs
power on sv
make sure you have pic on 100
put dongle in
wait for Ihub INI screen
than go to 200

this should allow the ip change to be updated

__________________

• Want to know when the new FTA Fix files are posted?
• General Helpful Hints on Forum Posting

Ok, I have tryed all the steps that you said, I even installed 6/25 bin and still no picture and showing all 0's when checking to see if connected to server when setting the DNS to NO. I did notice the the lights on the hub are on but steady. I Have now removed ethernet connction at the router and pluged in directly to the modem, I then retryed all the steps but still no picture . the green light is steady and the yellow is now flickering . I don't know if I need to change any of the settings in the IPCONFIG when connecting directly to the modem or not . I checked with my pc on line to make sure the server was up while doing my testing and it was.

can you atleast get like channel 100 ?

__________________

Yes I can get 100 and still getting 9421, 9491 with or without IHub.

here check this out mite be helpfull or maybe not!!!



iHub, how to get it re-talking to the I-net ......by-putski- 2009.06.10

This assumes that you have a operating DSL internet, and the hub is connected to the receiver and internet. The receiver has the current iHub software (.rom) installed. The iHub has been working, but it is no longer. This is what you need to do.
First with all power off, connect the hub to the receiver and internet connection.
Power up in sequence, the internet (modem and router), then the receiver.
After the receiver boots, then with remote goto Menu - Installation - IP Config
The header should say "User options"
Setup should match this post; http://www.ftaprofessionals.tv/sonicview-360-elite-instructions/4255-sonicview-ihub-configuration-set-up-instructions.html
Setting type DHCP - USE DNS YES - Domain name svftaiks.com - Server port 1920 - PUT IN YOUR iHUB's SERIAL NUMBER BE CAREFUL THE LETTERS ARE VERY SMALL
Now just simply enter them and Go to "Apply", click "OK".
Once above is done; Go to

"Setting Type" field and change to "Static" (this will allow you to access these fields);
Change the "Local IP" field to all zeros (000.00.0.0)
Change the "Local port" field to all zeros (0000)
Change the "Subnet" field to all zeros (000.000.000.0)
Change the "Gateway" field to all zeros (000.000.0.0)
Go to "Apply", click "OK

Now go to "Setting Type" field and change to "Static"
Go to "Apply", click "OK
Exit out.
The receiver should now be receiving and decoding the channels that are currently listed in the iHub list.
If not receiving, then; Power up in sequence, the internet (modem and router), then the receiver.
After the receiver boots, then with remote goto Menu - Installation - IP Config
The header should say "User options"
The fields previously with zeros should now have digits in them, if so, the hub/receiver is talking to the internet, if not check your internet equipment, and recheck the iHub setup.

__________________