i loaded the factor file bin and behold it brought up this disgnostic front key crap. every key stroke / botton i push just shows description of button pushed. how do i reset ? usb does not function due to no cotrol fuction. what do i do to fix this f**k up. thanks. help me team players.

one2, do you know how to load bin files through usb load? use a blank usb thumb drive and load the bin file on there you want. make sure that is the only bin file there. pop the usb stick in the usb port on the reciever while the reciever is powered off. hold down the menu or ok button on the front of the reciever and hold it while you turn the power on. once powered up, you can release the button once it says load usb. itll flash the bin file you have loaded on the stick. once its done, power off and back on! hope this helps you!

front eate test /LESL and holding the ok button when turning on did not work. any othet ideas ?

shos diagnostic NS WHEN POWERED SHOWS BOOT THEN 6 THE .. THEN ua1n , sv 360 elite-diagnostic ver 1.00 front key &ir press remote control or front key that's it , nothin but that. help help

ok here it is one more time. turning on it shows boot then the number 1 and then .. and test. screen says sv360 elite- diagnostic ver 1.00 front key & IR press remote control oe front key, that all it does.. team fta please help me.

i will have to push the old files thru with my laptop.with the rs22 cable to reset usb hub files config. right now it is not excepting the hub usb phase to re-set. will purchase 15 pin to 9 pin usb adaptor. lap top has 15 pins. hub has 9. tell then i will talk at ya later. fight time comenth.and away i go-ith.

Yeah force load factory file with pc loader.Have your loader ready to download the file and power the receiver up from the rear holding OK button on the receiver until it starts downloading.You should see the download % on yor pc.

__________________