hello, by ihub is bricked. I have the instructions from an FTA Pro to get rid of the 82. Problem is my local Ip is not 192.168.1.101 it is 174.89.144.24 can I input my IP in the fields in WIZnet and still follow the rest of the instructions or is there an easier way???? My wireless router is a Belkin G
Thank you

If that ip is assigned to your pc it will not work.You need to find a ip that pings within your routers ip range.



Check your Notifications/pm's.

__________________

ok ,yes you can manuel imput the ipconfig in your set-up. if you ping your address,do a COMMAND PROMPT with the start key stroke in your pc then write in IPCONFIG/ALL and look at your ip address.something like 196.168.10.100 is your working ip in your receiver. you should have different last four numbers such as 135. you can not use the same ip as your pc. if you set to dhcp and then enter config ip your box set-up it should select working ip for you.follow the reboot 82 direction step by step and you should have your ipconfig complete.good luck. reset / reboot your router also.look at your ip address in your pc networking.

I will give it a try, I'm not too sure of what I am doing, but I have nothing to lose. It must have been beginners luck with my 1st IHUB

well let us know if you get it running!
or if you need further assistance on setup!

__________________