How to install 8psk adapter and the 8psk module to the Viewsat 9000HD - FTA Files Community Forums for Satellite Equipment

**Fta Professionals** · #1 (**permalink**) 09-19-2008, 05:42 PM

You Tube

1) Turn OFF the receiver and unplug the power from the outlet
2) Unscrew 5 screw (2 on each side, and 1 in the back) to remove the case cover
3) Remove the module bracket
(after the bracket been removed)
4) Remove the sticker in the rear
3) Connect 2 cables to the sub-board
4) Connect the sub-board to the module .
Please be careful that Parts mounted surface should be up.
5) Connect LNB Power cable from the power supply board to the sub-board connector.
6) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.
7) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.
8) Fit the module thru the hole(reserved for the UHF remote antenna)in the rear of the receiver tight it
up using nut & washer
9) Connect a loop thru cable connecting the IF Output and the module input
10) Finishing job

**Fta Professionals** · #2 (**permalink**) 09-21-2008, 04:42 PM

Go to the Menu
Go to User Settings
Go to System Settings
At the bottom, you will now have the option to turn the External Tuner "ON". Do this.
I don't think this is necessary, but it's what I did... Factory Default to get rid of all current channels.
Go to Antenna Settings and setup your lnb/switch combinations.
Do "Auto Scan" on each of your sats individually.

This should get you what you want. Now enjoy TV, HD style!

**Fta Professionals** · #3 (**permalink**) 09-23-2008, 03:07 PM

Instructions with pictures are attached.