I will teach you how to get out of BOOT-LOOP with a VS9000HD receiver.

1. Make sure that you are in fact suffering from BOOT-LOOP. (BOOT) will be steady on your VS9000HD display and not move to the time setting.

2. Make sure that you have a Laptop and a NULL cable to connect between the Laptop and the receiver. REMOVE the receiver from all connections.

3. Find a solid copy of BOOT-LOADER 2 and (9000HDBoot fix_v2.pgm) to recover your VS9000HD receiver.

4. Connect the NULL cable to the receiver and Laptop and don’t power the receiver on at this time.

5. Launch BOOT-LOADER 2 from your laptop and open the file (9000HDBoot fix_v2.pgm)
make sure that you select (PC-STB) and click (OK).

6. Once the 9000HDBoot fix_v2.pgm) STARTS: turn on the receiver this will take about 6 seconds to get under way. Now because the fix file is about 33mb it will take some time to complete. My first try it took about 45 minutes but it works. You will see the indicator bar get out of sync and do strange stuff, don’t worry about what you see just let it finish.

7. When completed you will see completed on the laptop screen so select OK and turn the VS9000HD receiver OFF.

8. Locate a good copy of the (VS9000HD FIRMWARE) and load it into the laptop the same way you did with the (9000HDBoot fix_v2.pgm) file. Start the file and turn the receiver ON.
and let it complete. The receiver will now reboot and you will feel joy. Disconnect every thing and reconnect the receiver back to the Satelitte position.

9. You are now back to normal and at this point you can load the current bin file via USB or the laptop as you wish.

Tools you will need.

A fast Laptop with a NULL cable.
The Application BOOT-LOADER 2.
The file 9000HDBoot fix_v2.pgm).
The file Viewsat 9000HD Factory Bin File - V1007 or V1005.
The copy of the latest bin file, you can load this via USB.
And lots of good friends to help you with making decisions.

Hope this helps you with your BOOT-LOOP problem.