1. First you must download and unzip (extract) the yymmdd.pgm from the
Files section.

2. Insert your Memory Stick in your PC and either transfer the extracted
.pgm file from your computer or you can extract it directly to your USB
drive.

3. Insert the USB drive into your STB. (either rear or front - just make
sure you enable REAR USB or FRONT USB in the menu - under USER SETTING -
OPTION) If the STB doesn't recognize your flashdrive, make sure the drive
is formatted FAT32.

4. In the Main Menu select System information and press OK
Select Receiver Upgrade and press OK
Go down to the bottom of the window, select USB and press OK
A new window opens with files. Select your pgm file and press OK.
****************************** ********
VERY IMPORTANT. DO NOT TURN THE POWER OFF
Let the receiver finish and reboot on its own!!!
****************************** ********

5. Press Menu key, Select Installation and press OK
Select Antenna Setup and press OK
Select your Sat.
Here if you have a Diseqc switch enter the port #, Motor or Legacy SW
(appropriate to your setup).
Press Exit and select Yes for saving the settings
Your back to Antenna Setup screen

6. Set up each Sat you have by repeating step 5

7. Channel Scan (also from Installation menu)
Select Auto Scan
Press OK
You can change the sat you want to scan by using the F1 button and
selecting the sat to scan. Press exit to get out of the sat selection
menu.
Select Scan Start and press OK. Do this for all the Sats you have.

8. Exit and save the settings

9. Wait for Autoroll and watch TV

__________________

• Want to know when the new FTA Fix files are posted?
• General Helpful Hints on Forum Posting