Viewsat 2000 Ultra Setup Guide


If you follow this steps, your up and running in last than 5 min.
- Instal you STB and connect all the cables
- Turn the power ON from the back switch
- Press Menu key
- Select Installation and press OK
- Select Antenna Setup and press OK
- Select your Sat.
- Here if you have a DISEqC switch enter the port #, Motor or Legacy SW
- No LNB Type need to select (from new, you have only two selection Standard and Universal) The STB will select your LNB Automatic
- Press Exit and select Yes for saving the settings
- Your back to Antenna Setup screen
- Here you have Three choises:
- 1 Channel Scan
- 2 Auto Scan
- 3 Blind Scan
- I try all, but the best its Auto Scan
- Press OK
- You are in the Auto Scan window and you see the Bird(Sat.) you selected and in the top of your screen are three options:
- 1 Search option
- 2 Network search
- 3 Scan Start
- You don’t change nothing, go down and select Scan Start and press OK
- You do this for all the Birds (Sat.) you have
- Now its time to dowload you BIN
- Insert the Memory Stick in your PC and transfer the bin in. Than insert in your STB and in the Main Menu select System information and press OK
- Select Receiver Upgrade and press OK
- Go down to the bottom of the window, select USB and press OK
- A new window its open with some Corean files, years, etc.
- In the bottom of the window its your bin select and press OK
- VERRY IMPORTANT. DON’T TURN THE POWER OFF
- After you load the bin, the STB will reboot automatic
- Wait for Autoroll and wach TV

Attached Files

	VIEWSAT ULTRA HOW TO GUIDE.doc (1.10 MB, 124 views)
	Viewsat Ultra Configuration Guide.pdf (134.0 KB, 114 views)

Thanks to sk8rked

__________________

• Want to know when the new FTA Fix files are posted?
• General Helpful Hints on Forum Posting