Menu===>Installation then 0000 or 0937 or 2668 or 3570 then antenna setup then side arrow to ECHOSTAR 7=119W.then do the same for ECHOSTAR 8,10=110W,and NIMIQ 1,3=91.0W.

..............EchoStar 7=119W........................ .EchoStar 8,10=110W.
LNB Power................ON....... .................... ...............ON
LNB Type..............Standard.... .................... ..........Standard (Dish Pro change to OCS-DP)
LNB Freq...............11250...... .................... .............11250
22kHz.......................OF F................... .....................OFF
TP Freq.................12224.... .................... ...............12224 Or one that closer.
search option............ALL......... .................... ..............ALL
DiSEqC 1.0..............Port 1............................. ..........Port 2, (This should match the cable on the switch).
Motor......................OFF .................... ........................OFF
Legacy SW..............NONE.......... .................... ............NONE



NIMIQ 1,3=91.0W
LNB Power...........On
LNB Type............standard (Dish Pro change to OCS-DP)
LNB Freq.............11250
22kHz.................OFf
TP Freq...............12224 or one that is close.
DiSEqC 1.0...........Port 3 or 4 (this should match the cable on the switch).
Motor.................OFF
Legacy SW..........NONE

Perfect Scan with Dish500 and DishPro (Twin or Quad) LNB (Viewsat Receivers Only)

NOTE: Before performing any of these steps make sure you go into your antenna setup and write down each setup – You Will Need Them….

-First you will need to reset factory defaults

-Then go into your Antenna Setup and configure

- You will then set your LNB type to Standard and select the port on the DISEcQ where for this sat (119 = 1 & 110 = 2).

NOTE: If you are scanning 119 then you should turn the power off to the LNB of the antennas you are not scanning...

- Now commence your sat scan by selecting “F1” (The reason I use a Sat Scan vice a Blind Scan is because Viewsats have an option "Network Update" which by default is "On" and will automatically update all your Transponders eliminating the need for a Blind Scan)

NOTE: At the end of this process do the same for next sat repeating the steps above. Once you have completed all scans you will need to go back and reconfigure your antennas as follows:

LNB TYPE = OSC-DP
DISEcQ – 119 = 1 and 110 = 2.

NOTE: You should have not changed your DISEcQ settings but I posted them above anyway….

__________________

• Want to know when the new FTA Fix files are posted?
• General Helpful Hints on Forum Posting

Hey thats a kewl setup thank you

__________________