manual ....

supported boxes ...

Captive works 600s, 600sp, 650s, 700s and 800s models
Coolsat 4000,5000 and 6000 models
Viewsat 9000,Viewsat maxx HD, Viewsat Ultra
Azbox Evo XS,S700B,S710USB,S720USB models

And many other SSSP compatible receivers.

also compatible with AVR or Atmega (experts only), no more cable!,

supports distances of 30 meters indoors. (Not for SV)

set up Instructions

this one ...the box type ..


Step 1. Log into the x-fta dongle by connecting your pc into one of the 4 lan ports and grabbing a dhcp ip address.
after that you log into the web interface by typing 192.168.1.1 into the url bar of your web browser.

Step 2. Go to the connection page. Select wireless bridge. set the bridge ip to
an address in the subbnet of your primary router.
If your primary router is 192.168.0.1 then set it to 192.168.0.2 or similar. and if its 192.168.1.1 set it to 192.168.1.2 or similar. remember after you change this number and save, you will need to type that number into the url bar. Set the subnet mask to 255.255.255.0. set the ap/gateway ip address to that of your primary router. Like 192.168.0.1 or 192.168.1.1 depending on which brand you have. Select repeater disable.then click scan and select your primary router from the list. then enter your password if any and click save. wait about 2 minutes and enter the new ip address that you had selected for the bridge ip into the url bar.

Step 3. Relocate your x-fta dongle from your pc to your satellite receiver and connect the serial cable that came with your satellite receiver to the x-fta dongle. then power on the x-fta dongle and wait 2 minutes before connecting to it from your pc.
After you log into the x-fta dongle, please go to
the satellite menu and check enable rq-sssp.
then go down to receiver settings and and select which type of satellite receiver you have.
Coolsat, Captiveworks or gbox for all others.
Then go down to card server settings and on the existing one click edit.
Leave the host alone, set the port to 11112, username is YOURS and
your password is YOURS .
des key is YOURS .
then click close and apply, after that click save all followed by
build config file and then click start. and then you should have tv.

Attached Files

XFTA Dongle Nov 2010.pdf (18.6 KB, 54 views)

__________________

Please don't PM me with fta related questions, ask them in open forums so others can benefit from them too.